boot

  1. T

    Signal out of Range at Installation

    Hello everyone, im trying to install Proxmox 7.2 VE on my HP ProLiant DL380 G6. I get into the Bootloader and after booting the Kernel i see the initsystem Output. But at the Point where Xorg with the Installation starts, my Monitor (FullHD 60Hz) goes blank and shows an "Signal out of range...
  2. M

    grub: checksum verification failed

    Hello! I have a Proxmox host here which had a problem with one of 4 HDDs. This HDD has now been replaced, since then the host boots into grub rescue mode with "checksum verification failed", before the replacement the boot HDD was the (hd0), since replacement it is the (hd3,gpt3). After...
  3. G

    Please help a Novice

    Hey guys! I'm just a guy who has Proxmox to run a server at home. After running the server 24/7 for months, I cannot boot Proxmox anymore :(. I tried to fix the boot running the setup but I didn't fix it. I install a new version in a USB and I can see the SSD in Disks, but usage is 'NO', GPT...
  4. F

    [SOLVED] Efi boot zu klein, nach Umzug von grub zu uefi. Kernel Altbestände?

    Hallo, nach einem Umzug meines rpools von zwei Hdd auf zwei nvme habe ich auch gleich auf uefi gewechselt. Aber ich habe wohl etwas falsch gemacht. Jedenfals bekomme ich nach dem "sonst erfolgreichen" Umzug jetzt bei apt installs oder apt autoremove folgende fehlerhinweise: root@pve:~# apt...
  5. D

    [SOLVED] LXC container service only up after 5 minutes

    Hi, I am witnessing an issue with LXC containers in PE 7.2 with different containers, based on different templates (Debian 11 and Ubuntu 22.04) and now even different nodes. When I set up a container and install Docker with Portainer or AdGuard (which then would be the only service for the...
  6. Z

    Not able to boot in UEFI mode

    I have a Dell H310 Server with 8 1TB disks. I created one virtual disk with disk 1 and disk 2 with raid0 configuration. The other 6 disks are set to Non-RAID mode. Then I installed proxmox on the 6 disks with zfs raid10 configuration. The virtual disk will be used for backup storage. Now, in...
  7. F

    ACPI error: No handler for Region[SYSI] Intel(R) I/OAT DMA Engine init failed

    After performing some upgrades, I noticed that the server didn't came back online. I was abroad at that time. Now I see via the iDRAC console that I have a ACPI error: No handler for Region[SYSI] 00000000f42c25ab [IPMI. I found a similar thread here which let me go a little bit further. It...
  8. X

    Host ohne UEFI | Gast mit UEFI

    Liebes Forum, wenn der Host kein UEFI BIOS hat, sprich im Legacy Mode gebooted worden ist, gibt es dann die Moeglichkeit den Gast im PROXMOX mit UEFI zu booten? Mir ist aufgefallen, dass bei qemu die Moeglichkeit besteht, den Gast mit dem Parameter '-bios /usr/share/ovmf/OVMF.fd' zu starten...
  9. F

    Unterbruch während Bootvorgang

    Hallo zusammen, wir haben zum wiederholten Male ein recht unangenehmes Phänomen beobachtet: Proxmox1 wird gebootet, was bei Proxmox2 dazu führt, dass es einen kurzen Netzwerkunterbruch gibt. Gibt es hier bekannte ähnliche Fälle? Was genau tut ein Proxmox wenn er bootet, was so ein Verhalten...
  10. B

    [SOLVED] Is it safe to format a potential ESP with FS type zfs_member? (Proxmox Boot Tool)

    Hi everyone! Another post in the saga of upgrading my Proxmox node from PVE 6 to 7. This time I'm trying to switch my legacy boot system to the Proxmox Boot Tool. For reference I've been following this guide on the wiki and am currently using RAID-Z1 with two disks. When I run lsblk to find...
  11. Z

    [SOLVED] opnsense can't boot

    Hello, i was trying to boot opnsense but the .img file not readable by the bios or there something wrong i try nano & vga but no luck the version nano: OPNsense-22.1.2-OpenSSL-nano-amd64.img the version vga: OPNsense-22.1.2-OpenSSL-vga-amd64.img so any one facing the same issue and success on...
  12. T

    Upgrade from 7.0.10 Kernel 5.11.22-7 to 7.2.4 Kernel 5.15.35-1 Cannot Process Volume Group PVE

    Why Hello There! This evening I performed a regular upgrade to a client's long-standing (~2 years) hyperconverged PVE cluster. This cluster has some history but for the most part has been trouble free. The cluster is made up of homogeneous hardware, all Gen8 HPE Proliant servers with one node...
  13. N

    Kernel panic not syncing VFS unable to mount root fs on unknown-block AND MORE ERRORS

    I use Virtual Environment 5.4-13 My problem is with a guest machine with CloudLinux. My server crashed and when I opened the console it appeared: After resetting the system, I encountered this and it froze: Reset did not solve the problem: Finally, when booting, I changed the kernel...
  14. L

    /boot partition auslagern ?

    Hallo zusammen, mein Server (HP Proliant 360 gen8) bootet nicht von seinen Festplatten, wenn der RAID-Controller im "HBA-Modus" betrieben wird. Sprich : ich kann nicht von Festplatte booten, wenn ich aus dem "RAID-Modus" raus bin.. Nun zu meiner Frage: Der Server bootet aber von USB/bzw...
  15. C

    Windows 2016 black screen during boot

    Hola, I am running 200+ vm's on 5 node cluster with 3 node Ceph strorage. Mainly W2019 and about a dozen W2016. 1 W2016 machine running SQL has a strange phenomenon. When i do a restart the following happens: Bios screen Proxmox shows shortly. Than the machine hangs for about 30 minutes...
  16. T

    How to switch from legacy to EFI boot

    So my setup is I installed a version prior to Proxmox VE 6.4 on my server and recently updated everything to VE 7.1. Since the installation was done in legacy mode I switched to the "Proxmox Boot Tool" which was recommended because of problems with GRUB and ZFS. So I used this tutorial...
  17. T

    Proxmox 7.0 Upgrade - Legacy Boot Tool

    Wir möchten gerne unseren Proxmox Server von Version 6.4 auf 7.0 (oder auch 7.1) upgraden. Da unser Server nicht mit UEFI installiert wurde habe ich gelesen das ich zu dem "Proxmox Legacy Boot" switchen soll, da GRUB Probleme hat wenn ZFS auf der Root Partition läuft. Dafür sollen die vfat...
  18. S

    Windows 11 VM: USB Boot funktioniert nicht

    Hallo zusammen, Ich betreibe Proxmox in der aktuellen Version mit u.a. einer Windows 11 VM. Der im Host eingesteckte bootfähige USB-Stick wird erkannt und richtig in die VM durchgereicht. Der Stick bootet in eine physischen PC einwandfrei, in der VM jedoch nicht, weil er im Bootvorgang nicht...
  19. D

    [SOLVED] template creation with Packer: boot options menu appears on some cluster and not other

    Hello, We are in the process of installing and configuring 4 clusters of 3 nodes and automating templates creation using Packer. We have a strange behaviour where for some clusters Packer template creation works fine and for others we are faced with a bug during the boot process. First, some...
  20. A

    GRUB shows for a split second when installing proxmox

    Hi. I don´t know if this is a dumb question but i am trying to install proxmox on an old laptop with broken screen. I am installing from USB and would like to disable the built in display in grub boot menu as the screen is extended and i can only see the blank extended part on my second...