Need Help - Proxmox with pfSense (1x NIC, 2x IPv4)

[TixmTV]

Hello,

I have rented a dedicated server.
I have proxmox installed on it.
Now I want to use pfSense as firewall and for internal routing of the other VMs.

My goal is to:
- An IPv4 for the host on which proxmox runs and is callable on the internet over it.
- An IPv4 for the VM of pfSense, so that I can bring all other VMs over this into the Internet.
- All other VMs should be connected to pfSense via LAN.


My IPv4s:
- Main: 89.x.x.248
- Second: 5.x.x.211

I am relatively new to this topic, so I need your help to apply the configuration correctly.


With kind regards
Tim B.

 

[patch]

I have proxmox installed on it.
Now I want to use pfSense as firewall and for internal routing of the other VMs.

Start with Proxmox virtualisation in Netgate manual
and Netgate virtualisation forum

Configure two bridge in Proxmox to connect to pfsense

1. WAN
2. Lan

Or use VLAN in pfsense to separate the WAN and LAN interfaces (router on a stick), and use VLAN controls in Proxmox to separate the interfaces

 

[TixmTV]

Start with Proxmox virtualisation in Netgate manual
and Netgate virtualisation forum

Configure two bridge in Proxmox to connect to pfsense

1. WAN
2. Lan

Or use VLAN in pfsense to separate the WAN and LAN interfaces, and use VLAN controls in Proxmox to separate the interfaces

Thanks, but what should my setup look like then?

Currently it looks like this:

enp2s0:
- IPv4: 89.x.x.248/32 (this is my main IP)
- Gateway: 89.x.x.1
- Subnet mask: 255.255.255.255


So should I then create a bridge to which I assign the other IP so I can use it for pfSense?

Or maybe you could write down an example for me how it should look approximately in Proxmox.