Hi there!
I'm attempting to configure dual GPU passhtrough to two guest Win10 VMs.
I managed to pass the first GPU to a Win10 guest just fine (GTX 750Ti). I then decided to add the second GPU (GTX980), so I included its IDs to "/etc/modprobe.d/vfio.conf" and rebooted the server as per the instructions (I've been following this really awesome guide). The server then hangs during boot once it checks the disk. I tried disabling fastboot to see whether that would make a difference, but then boot stops at "2 logical volume(s) in volume group "pve" now active.
The PC also has Intel interated graphics and I thought it wouldn't need much else than that to boot, and a GPU is not mentioned in the minimum requirements as far as I could tell.
Any ideas what the issue may be?
I'm attempting to configure dual GPU passhtrough to two guest Win10 VMs.
I managed to pass the first GPU to a Win10 guest just fine (GTX 750Ti). I then decided to add the second GPU (GTX980), so I included its IDs to "/etc/modprobe.d/vfio.conf" and rebooted the server as per the instructions (I've been following this really awesome guide). The server then hangs during boot once it checks the disk. I tried disabling fastboot to see whether that would make a difference, but then boot stops at "2 logical volume(s) in volume group "pve" now active.
The PC also has Intel interated graphics and I thought it wouldn't need much else than that to boot, and a GPU is not mentioned in the minimum requirements as far as I could tell.
Any ideas what the issue may be?