bond

Hi, I have Blades with 2x Eth devices, each one connected to switch module, I create bonds for that 2 eth for HA and this bond got the "Public / Internet" IP, now, I need to add additional Private IPs to same bond, now can I do that? how can I set additional IPs for same bond and same Bond...

Hey everyone, I'm currently building a "proof-of-concept" for work using Proxmox. I have a 4x1Gb LACP config (see below), but I get slow performance from my VMs. I'm using a 400MBps NAS storage that works perfectly when a 10Gb non-vm client is tested. On Proxmox I have 3, Win 2012 r2 VM's with...

Hi! So I'm pretty new to this and I'm a bit confused about how to make Proxmox belong to a VLAN. I have a VM running VyOS with two virtual interfaces tagged with VLAN 10(LAN) and VLAN 99(WAN) and that works just fine and dandy but I can't access the GUI to Proxmox or SSH into it since Proxmox...

Hi All I have only 2 Nic interfaces. I want configure proxmox 4.4 using bond configuration. Follow post my actually interfaces configuration. switch in Trunk mode. auto lo iface lo inet loopback iface eth0 inet manual mtu 9000 iface eth1 inet manual mtu 9000 auto bond0 iface...

Hi, I'm seeing some weird network activity on the guest on the summary page. For each guest I see the same network activity, as if the activity was showing actually the host network activity. I'm using bonded interfaces (mode 1). Maybe this is the problem? For instance, I'm sending some data to...

This is just a quick recommendation to those who seek improved network performance. Previously we used to use just one interface and leave one spare as by default OVH did not set it up. Tonight we configured a bond and used the 802.3ad mode and we have seen massive performance improvements...

Hallo. Wir sind gerade dabei, auf einem Testsystem Subnetting & VLANs einzurichten. Wir haben zusätzlich ein bond0 (mit 4 slaves) erzeugt, auf dem alle VLANs getaggt in den Proxmox-Server gelangen (4-fach NIC). Nun ist es in der GUI einerseits möglich, eine neue "Bridge.VLAN-ID" (z.B...

This configuration (perhaps you'll call it a work-around) took me a while to sort out, so hopefully it will save you some time. The problem: When you bond 2 interfaces and then want to make a "vmbr" (for example vmbr0) over them, you'll find that the moment a VM starts with the same vlan tag as...

Hi, I've been looking over a lot of different information over the last couple of hours and can't quite figure out how do what i want to do. I like to note I'm not a networking master, far from it. I'm a developer mainly working on PHP and Java, I've ended up needing to learn these new skills...

greetings, I'll try this here hope someone will be able to answer or point me to the right direction. here is the scenario: lets say I have a 'diskless server' (will be virtuallized essentially), this specific server serves workstations without physical disk to be able to boot windows...