Pci bus error security uncorrected

[kotovasia]

Installation error.
My system:
Xeon e5 2667v4
atermiter x99
gtx1070ti


I think this is possible due to the edited Bios.
Is it possible to bypass this message during installation? And will this cause real errors to be ignored?
I'll try installing it with standard BIOS one of these days.

 

[showiproute]

No as long as you did not do something totally weird with BIOS/UEFI Proxmox is not really bothering about it.

What I do see and what might causes the problems is the line with "no device with valid ISO found..." - have you double checked that?

 

[kotovasia]

Нет, пока вы не сделали что-то совершенно странное с BIOS/UEFI, Proxmox не особо об этом беспокоится.

Что я вижу и что может вызвать проблемы, так это строка «Устройство с действительным ISO не найдено...» - вы это дважды проверили?

Yes, I rewrote the iso and this warning disappeared. But as for pci, it remained

 

[showiproute]

A quick search on the internet may indicate that your GPU is causing those error messages.
You can try to install Proxmox anyway and see if it runs.

Adding pci=noaer to your bootloader should solve the problem afterwards

 

[kotovasia]

A quick search on the internet may indicate that your GPU is causing those error messages.
You can try to install Proxmox anyway and see if it runs.

Adding pci=noaer to your bootloader should solve the problem afterwards

I added support for "above 4g decode" to the BIOS.
In Windows, the video card passes all tests and has never had any problems. Where should I enter PCI=noaer And won't this hide the real problems when they appear?

 

[showiproute]

I added support for "above 4g decode" to the BIOS.
In Windows, the video card passes all tests and has never had any problems. Where should I enter PCI=noaer And won't this hide the real problems when they appear?

I also enabled this feature - didn't harm any of my servers.
The command should be added to either grub or systemd bootloader - depending on what you are using --> https://pve.proxmox.com/wiki/Host_Bootloader

Simply add it there and rerun the config command to enable it. After that you should no longer see those Nvidia related errors.

 

[kotovasia]

I also enabled this feature - didn't harm any of my servers.
The command should be added to either grub or systemd bootloader - depending on what you are using --> https://pve.proxmox.com/wiki/Host_Bootloader

Simply add it there and rerun the config command to enable it. After that you should no longer see those Nvidia related errors.

I didn't figure out how to use this during the initial installation.
I’ll also clarify what I used YUMI For loading. And in the BIOS the boot picture has also been changed.

 

[showiproute]

No, you need to add this after you have installed PVE on your hardware.

 

[kotovasia]

No, you need to add this after you have installed PVE on your hardware.

The error appears during the initial installation.

 

[showiproute]

Yeah I know and as mentioned earlier you can ignore this during your installation.

 

[kotovasia]

Yeah I know and as mentioned earlier you can ignore this during your installation.

I don't understand how to skip this. Messages are cyclical.

 

[showiproute]

Can you boot into Proxmox installer?