Out of RAID drives / standalone drives not detected by Proxmox

[tigerblue77]

Hi everyone,

I'm actually trying to build a Proxmox cluster of HP DL380 G5 (kind of old school but effective...) and, following Ceph instructions, I just made a RAID 1 for my OS (Proxmox) partition and let others drives free, in no RAID.

The problem is that they are not showing in my proxmox host



How should I proceed to make them accessible and add them to ceph ? Thanks !

 

[Dark26]

Do you see them in the gui ?

 

[czechsys]

You need set every other drive set as raid0.

G5? Really? GL with performance.

 

[tigerblue77]

Do you see them in the gui ?

Hi, thanks for your prompt answer. Apparently not :

 

[tigerblue77]

You need set every other drive set as raid0.

G5? Really? GL with performance.

Are you sure that I have to make 6 RAID 0 ? (1 per drive)

Performance is not a problem actually, it's only for testing purpose

 

[sg90]

Are you sure that I have to make 6 RAID 0 ? (1 per drive)

Performance is not a problem actually, it's only for testing purpose

Yes until you setup some form of raid on the HP controller it will not pass through the disk to the OS.

Make 6 indvidual Raid 0 (1 per a drive) in the HP Raid setup and Promox will then see these.

 

[tigerblue77]

Yes until you setup some form of raid on the HP controller it will not pass through the disk to the OS.

Make 6 indvidual Raid 0 (1 per a drive) in the HP Raid setup and Promox will then see these.

Okay ! Thanks for your answer, have a good christmas !