pve-cluster

Hello everybody, I'm writing this short article because I spend myself a lot of time by finding the right configuration to get this working. First of all: A 2 Node Cluster is not a very good way to create High-Availability or even Fail-over scenarios because corosync is not able to create a...

Following up my previous thread ( which has no solution at the moment ), I started searching what actually failed in my attempt to create clustering with running virtual machines. Commands run adn output: root@xxxxx:~# sqlite3 /var/lib/pve-cluster/config.db SQLite version 3.8.7.1 2014-10-29...

I have a cluster with 2 nodes, and as configured by default, they both have 1 vote and will not reach quorum: Votequorum information ---------------------- Expected votes: 2 Highest expected: 2 Total votes: 1 Quorum: 2 Activity blocked Flags: I've tried stopping the...

Hi, I have a cluster setup with 2 nodes (proxmox01 and proxmox02). Proxmox01 is my primary node, then Proxmox02 is my second. What I noticed is everytime proxmox02 gets a bit loaded (system load reach around 2.0) because of the "kvm" process, it automatically get disconnected from the cluster...

I have been pulling my hair out today and have reinstalled Proxmox on 3 different servers about 4 times each so far because not only does it not work but I can't seem to revert back either. I have 3 servers (nodes) running Proxmox 4.2-23 All 3 servers are on an RPN network as well as having...

Hi, I have a fresh setup of Proxmox VE 4.2-15 cluster with two nodes running, Proxmox01 and Proxmox02. Using Proxmox01's UI as my management UI, I'm able to deploy and setup a VM on Proxmox01 with no sweat. However, I'm having an issue deploying a VM in Proxmox02 (using Proxmox01's UI). I was...

I have 2 nodes + 1 quorum total 3 machines. From GUI, this is the status of the HA: I know something is not right and I notice all the machine has no pve-cluster process running. Should I run pve-cluster (service pve-cluster start) on all of the machines? or just on particular machine...

After doing a simple `apt-get upgrade` on my older pve 3.4, it didn't come back online due to a kernel panic (can't find /etc/zfs/zfs-functions). Not the end of the world I thought, let's use the opportunity and upgrade to 4.2. After a clean install (again zfs raid 1) and some zpool-hassle, I...