Hi everyone, merry christmas to you
I am currently rebuilding my server rack and also switched from XCP-ng to Proxmox. Right now I am trying to configure my new 10Gb setup with managed switches (Netgear) and Proxmox.
I have four VLANS (280-283), 280 is the management VLAN. This is also where the proxmox interface should be reachable. 281-283 will be used for other services.
The hypervisor is connected to the switch using two 10Gb RJ-45 ports with LACP, 281-283 as trunk (tagged) and 280 (untagged).
However no connectivity from proxmox to the network is possible right now. There are similar forum posts but I did not succeed implementing the provided answers. I don't know where the problem is exactly but I'll start with proxmox. Could you verify that my network config in pve should work?
interfaces:
Within my the netgear switch it states a connection, but still there's no connectivity. Just for a complete picture, this is how the switch is configured right now:
Happy for any advice
Thanks a lot!
Alex
I am currently rebuilding my server rack and also switched from XCP-ng to Proxmox. Right now I am trying to configure my new 10Gb setup with managed switches (Netgear) and Proxmox.
I have four VLANS (280-283), 280 is the management VLAN. This is also where the proxmox interface should be reachable. 281-283 will be used for other services.
The hypervisor is connected to the switch using two 10Gb RJ-45 ports with LACP, 281-283 as trunk (tagged) and 280 (untagged).
However no connectivity from proxmox to the network is possible right now. There are similar forum posts but I did not succeed implementing the provided answers. I don't know where the problem is exactly but I'll start with proxmox. Could you verify that my network config in pve should work?
interfaces:
auto lo
iface lo inet loopback
#onboard GbE1
iface eno1 inet manual
#onboard GbE2
iface eno2 inet manual
#10GbE RJ-45 1
iface enp40s0f0 inet manual
#10GbE RJ-45 2
iface enp40s0f1 inet manual
#Dual 10GbE LACP
auto bond0
iface bond0 inet manual
bond-slaves enp40s0f0 enp40s0f1
bond-miimon 100
bond-mode 4
bond-xmit-hash-policy layer2+3
bond-lacp-rate 0
bond-downdelay 200
bond-updelay 200
bond-min-links 1
mtu 1500
#Default bridge
auto vmbr0
iface vmbr0 inet static
bridge-ports bond0
bridge-stp off
bridge-fd 0
#Honor VLAN tags:
bridge-vlan-aware yes
bridge-vids 1-4094
#Management Interface (VLAN 280)
auto vmbr0.280
iface vmbr0.280 inet static
address 172.28.0.101/24
gateway 172.28.0.1
dns-nameservers 172.28.0.1
Within my the netgear switch it states a connection, but still there's no connectivity. Just for a complete picture, this is how the switch is configured right now:
Happy for any advice
Thanks a lot!
Alex