Add route on Proxmox host through GUI?

[Boman]

Is it possible to add a route entry through the GUI for a Proxmox host?

I could of course add i the route in /etc/network/interfaces as a post-upp directive but this file is updated by Proxmox when changing stuff in the GUI so I'm afraid it will get overwritten.

In summary, what is the "correct" way of adding routes to Proxmox hosts?

Best regards,
/David Boman

 

[spirit]

post-up is the right way, it's not possible to do it from gui currently, but gui changes should not remove it

 

[Boman]

Ok, then I will use a post-up directive.

Thank you very much!

 

[poetry]

If anyone is looking for an example:
post-up ip route add 192.168.2.0/24 via 192.168.2.1 dev ens192

Would be nice if this could be done via GUI sometime in the future.

 

[c9nbv]

for me it was:
ip route add 192.168.3.0/24 via 10.0.11.254

when you do it like this, you can check with:
ip route

It will automatically add the dev interface it finds the gateway on, be sure to have connected the vlan on an interface to Proxmox good luck.