fujitsu

I wanted to check is it possible to migrate ESXi by replacing usb stick with the one with proxmox. It kinda worked but I have problem with detecting Mega RAID. This is Fujitsu PRIMERGY RX1330 M2 and it have FUJITSU PRAID CP400i on board. I also have TX2550 M4 with some newer RAID controller but...

[TL.DR]: RAID card firmware bug seems to cause a non boot issue on Kernel 6.8.4-N-pve, works on 6.5.13-5-pve. Any ideas on how to fix? Today I have done a lot of troubleshooting for one of my Proxmox servers. It started when I was rebooting the server after some updates. Suddenly it wasn't...

Hello, I am facing problem while installing proxmox 8.0 on Fujitsu PRIMERGY TX1320 M3 server with FUJITSU PRAID CP400i. Both bios and FW raid cards are the latest from the Fujitsu website. When I try to install proxmox I see in the error log megaraid_sas Init cmd return status failed for...

Hi there, I just bought a Fujitsu Primergy RX300 S7 and 6 new SAS HDDs. Installed Proxmox and plugged the HDDs into their bays. Everything works fine in proxmox except it cannot detect my SAS drives, only the two SSDs I installed on SATA ports for running OS. The SAS drives do pop up when...

Proxmox 7.3-3 Windows 10 Pro guest I previously had this document scanner attached under Proxmox 7.1 but after upgrading to 7.2 and beyond, the scanner is no longer seen by Windows. This is regardless of whether I remove the device and add again via vendor/ID or full passthrough. Nothing is...

Hello I bought Fujitsu TX1330 M4 server hardware and Windows Server 2022 Essentials (ROK for Fujitsu only). When installing directly on hardware the setup reads BIOS and install goes on. But on Proxmox there is a message that Fujitsu hardware is required and it stops. I was trying to add some...

Hi Proxmoxers. After restarting PVE nodes previously upgraded from 5.3.13-1 to 5.4.65-1 kernel, we lost connectivity with LUNs provided by Fujitsu Eternus DX100 S4 - FC interface connected to QLogic 2692 Host Bus Adapters in servers. It's not multipath issue, as we cannot see the storage devices...

Hallo zusammen, ich wollte mal nachfragen ob jemand Erfahrungen mit dem Hardware Raid Controller PRAID CP400i von Fujitsu und Proxmox hat? Ich wollte auf einem Fujitsu PY RX1330M3 mit einem RAID 5 einen Proxmox installieren. Bevor ich den Server kaufen, wollte ich wissen ob es überhaupt...