Recent content by roomwillow

Hello, I have a ProxMox cluster I am trying to attach to an SMB share, the SMB share is hosted on FreeNAS, and is authenticated via active directory, I have tested the share to rule out basic connectivity/permissions issues, from a windows 10 system I am able to connect and authenticate to the...

Not sure if this is the appropriate place to post this, but I'd love to see VM Categories, the ability to assign VMs a "department", or "category, we have 40-50ish VMs across 4 hypervisors and it can be a little tedious tracking which group which VM belongs to, we've resorted to putting...

yea no nothing about lvm-commands, vgdisplay, or pvdisplay, I see directories on the SSD directly "dump" "images" "private" "snippets" "template", "images" appears to have all the VMs in their own directories inside, what I ended up doing was connecting the SSD back to the laptop, putting a...

Unfortunately, this was a mistake made by another tech, I'm just left to pick up the pieces, he had an SSD installed in a system, the SSD was run through a RAID card in RAID0, the SSD was then moved to a different raid card where the array was upgraded, then it was put onto an HBA, to no...

Hello, I have been running ProxMox for some time now on a single server, 120gb SSD for boot and 240gb RAID 1 (via Dell h700 raid card) for VMs, I had some difficulty with storage when I first setup ProxMox, coming from ESXi but switching for the clustering/HA features, I ended up with a...

I am new to ProxMox so excuse any stupid questions, to my understanding, a management interface is just a bridge with an IP address... correct? In that case, I have the bridge attached to a bond, and I want the bridge to be tagged so its traffic (including the management interface on top of it)...

I was doing this while I was tired last night, turns out i left the LAG group on the switch set to access instead of trunk, and had the wrong pvid, fixed that and it started working right away. Thanks!

I'm new to ProxMox so excuse if I'm misunderstanding, I created a bond of eno2, eno3, eno4, (bond0) in LACP mode, it's listed as not vlan aware, and I have a windows 10 VM attached to vmbr1 which is using bond0 as its port, the VM interface is tagged 400, and is unable to ping anything on the...