Zeoss container using template does not finish installation.

[vcp_ai]

I'm opening this thread, because the only thread found was related to PVE 1.x

Runing PVE 2.2.31.
This is my first OpenVZ container. (I've used instructions from http://pve.proxmox.com/wiki/Installation) .....

Installed from template 2.5.1

I've defined cointainer with 4GB (after reading PVE 1.x related post http://forum.proxmox.com/threads/656-New-Zenoss-Appliance-for-Proxmox-VE-(Version-2-2-3))
I've defined eth0 both as NAT an bridged mode. Same results

Sympton:
On machine start, open console, and after some scrolls, get to:

Daemon : xxxxx  starting (12 of them)
Daemon : zenevetlog  starting ...
 * Starting deferre execution scheduler atd
 * Starting perodic command scheduler crond 
 * Running local boot scripts (/etc/rc.local)
I can not see the rigth part of the console for these last three comands, it only shows an [B][[/B]   - like an [OK] -

And at this point it 'freezes' no more output .....


Any hints

 

[tom]

also check http://pve.proxmox.com/wiki/OpenVZ_Console

the template is outdated, I suggest you install a debian 6 container and then follow the zenoss howto.

 

[vcp_ai]

Thanks vzctl enter VMID did the trick, ...

Will try Zeoss and if found usefull, will follow your suggestion to install from Zeoss web.

Regards