Zeoss container using template does not finish installation.

vcp_ai

Renowned Member
Jul 28, 2010
177
5
83
Valencia -Spain-
I'm opening this thread, because the only thread found was related to PVE 1.x

Runing PVE 2.2.31.
This is my first OpenVZ container. (I've used instructions from http://pve.proxmox.com/wiki/Installation) .....

Installed from template 2.5.1

I've defined cointainer with 4GB (after reading PVE 1.x related post http://forum.proxmox.com/threads/656-New-Zenoss-Appliance-for-Proxmox-VE-(Version-2-2-3))
I've defined eth0 both as NAT an bridged mode. Same results

Sympton:
On machine start, open console, and after some scrolls, get to:
Code:
Daemon : xxxxx  starting (12 of them)
Daemon : zenevetlog  starting ...
 * Starting deferre execution scheduler atd
 * Starting perodic command scheduler crond 
 * Running local boot scripts (/etc/rc.local)
I can not see the rigth part of the console for these last three comands, it only shows an [B][[/B]   - like an [OK] -
And at this point it 'freezes' no more output .....


Any hints
 
Thanks vzctl enter VMID did the trick, ...

Will try Zeoss and if found usefull, will follow your suggestion to install from Zeoss web.

Regards
 

About

The Proxmox community has been around for many years and offers help and support for Proxmox VE, Proxmox Backup Server, and Proxmox Mail Gateway.
We think our community is one of the best thanks to people like you!

Get your subscription!

The Proxmox team works very hard to make sure you are running the best software and getting stable updates and security enhancements, as well as quick enterprise support. Tens of thousands of happy customers have a Proxmox subscription. Get yours easily in our online shop.

Buy now!