[SOLVED] Speed MAX 11,5Mb/sec ..... Why??

[Zippi]

Hi, I installed ProxMox VE on a HP ProLiant MicroServer Gen 8.
I tried all the possible configuration combinations of the Samsung EVO 860 ssd HDD but for example when I load an ISO image I can't get more than 11.5Mb/sec of transfer rate.
Tried in AHCI, Tried in RAID 0 but nothing to do.
It doesn't go more than 11.5Mb/sec.
Is it possible that this is the maximum speed?
Where am I wrong?
Thanks if anyone can help me because I don't know where to hit my head anymore!
Thank you
Zippi

 

[Dunuin]

I would benchmark the storage with fio and the network with iperf. Then you see where the bottleneck is.

 

[leesteken]

It doesn't go more than 11.5Mb/sec.

That is close to the USB 1.x maximum speed (12Mbit/sec) and also the maximum speed of 802.11b WiFi (11Mbit/sec). Are you using a USB network adapter or a WiFi network?

 

[Zippi]

I would benchmark the storage with fio and the network with iperf. Then you see where the bottleneck is.

Hi, thanks for the reply but I don't know how to do it.
Can I use my iMac against HP Gen 8 to do these tests?
How should I do?
I'm no expert, if you can help me thank you very much!

 

[Zippi]

That is close to the USB 1.x maximum speed (12Mbit/sec) and also the maximum speed of 802.11b WiFi (11Mbit/sec). Are you using a USB network adapter or a WiFi network?

It's all connected via cable 1Gbps - UniFi switch

 

[apoc]

Does it actually sync with 1Gbit?
11.5 mb also could be an issue in cabeling and a 100Mbit connection

 

[Zippi]

Does it actually sync with 1Gbit?
11.5 mb also could be an issue in cabeling and a 100Mbit connection

You are right!
I suspected it too, but since the connection worked, I thought maybe there was an incompatibility of the drivers with the network card, but it seemed too strange to me.
I checked and the led on the switch was orange at 100Mbit and not green at 1Gbit.
I thought I had a broken switch channel and instead it was simply a DAMN Cat 6 CABLE that works but only goes to 100Mbit !!!!!
Needless to say, I already burned it!

I apologize to all and thank you for your patience but not being an expert I was going crazy after all the tests (except one) I had done.
Thanks again everyone!

 

[apoc]

I apologize to all and thank you for your patience

No worries. It is easy to overlook the most Fundamental things, because we assume they are so basic that they just work.

 

[Docop2]

I got the same last month. 100mb run with 1 pair and on mine it was 1 of the side pin that wasn't crimp properly.. or wire not deep enought to make proper contact.