[ SOLVED ] Network configuration

  • Thread starter Thread starter Tuxxin
  • Start date Start date
T

Tuxxin

Guest
Hello. I'm currently setting up a proxmox cluster over 4 nodes. Each has Duel xeon e55xx, 32gb ram, a single 64Gb SSD and 4x 10/100/1000 NIC's. We also have a SAN w/LSI MegaRaid card and a pure SSD storage array. Our plan is to run 2x iSCSI and 2x Public both running off redundant power, switches, etc for true HA. My question is what is the best option for active/active failover on the public interfaces?

Thank you.
 
Last edited by a moderator:
Re: Network configuration

Does anyone have any input on this? Was I not clear enough on my question? Any help would be great. Thanks.
 
Re: Network configuration

I read over the thread you suggested but it's not exactly what I'm looking for.

My question is this: I have 2 public ehternet devices on each node. Each of these devices run from a separate switch. How can I add an active/active failover/redundancy to one another (ie: eth0 goes down, eth1 picks up all traffic for VM's attached to eth0)?

Thanks in advance :)
 
You must log in or register to reply here.
Top Bottom
Back