Hello everybody
I'm a real newbie in terms of proxmox but I had good knowledge of Linux in past life.
I'm at my first install of proxmox on an x99 motherboard with Xeon E5 2670 CPU, 32GB RAM, 2 NVME, 1 hdd
Every component was tested under windows and it is working fine.
Now when I boot from USB stick with proxmox v. 6.2 installation program, it freezes after few seconds with multiple messages saying
cpu srcid #0 ha #0 channel #0 has dimms but ecc is disabled
Is it a known problem? Shall I boot with some specific parameter? (BTW how can I pass boot parameters to the kernel?)
Any hint will be very much appreciated
Thanks
blackdir
I'm a real newbie in terms of proxmox but I had good knowledge of Linux in past life.
I'm at my first install of proxmox on an x99 motherboard with Xeon E5 2670 CPU, 32GB RAM, 2 NVME, 1 hdd
Every component was tested under windows and it is working fine.
Now when I boot from USB stick with proxmox v. 6.2 installation program, it freezes after few seconds with multiple messages saying
cpu srcid #0 ha #0 channel #0 has dimms but ecc is disabled
Is it a known problem? Shall I boot with some specific parameter? (BTW how can I pass boot parameters to the kernel?)
Any hint will be very much appreciated
Thanks
blackdir