Proxmox does not recognize ssd

[Honk2006]

Hey, I have a new server here with a broadcom 9600-16i HBA but Proxmox does not show me the disk in the UI but if i pull a disk out it show this error:
Apr 30 17:51:40 pve1 kernel: mpi3mr0: SAS Discovery: (start) status (0x00000000)
Apr 30 17:51:40 pve1 kernel: mpi3mr0: SAS Topology Change List
Apr 30 17:51:40 pve1 kernel: mpi3mr0: mpi3mr_sastopochg_evt_debug :sas topology change: (direct attached)
Apr 30 17:51:40 pve1 kernel: mpi3mr0: SAS Discovery: (stop) status (0x00000000)
Apr 30 17:51:40 pve1 kernel: mpi3mr0: mpi3mr_sastopochg_evt_debug : expander_handle(0x0000), port(255), enclosure_handle(0x0001) start_phy(29), num_entries(1)
Apr 30 17:51:40 pve1 kernel: mpi3mr0: mpi3mr_sastopochg_evt_debug : phy(29), attached_handle(0x0005): delay target remove: link rate: new(0x00), old(0x0b)
Apr 30 17:51:43 pve1 kernel: mpi3mr0: SAS Discovery: (start) status (0x00000000)
Apr 30 17:51:43 pve1 kernel: mpi3mr0: SAS Topology Change List
Apr 30 17:51:43 pve1 kernel: mpi3mr0: mpi3mr_sastopochg_evt_debug :sas topology change: (direct attached)
Apr 30 17:51:43 pve1 kernel: mpi3mr0: SAS Discovery: (stop) status (0x00000000)
Apr 30 17:51:43 pve1 kernel: mpi3mr0: mpi3mr_sastopochg_evt_debug : expander_handle(0x0000), port(255), enclosure_handle(0x0001) start_phy(29), num_entries(1)
Apr 30 17:51:43 pve1 kernel: mpi3mr0: mpi3mr_sastopochg_evt_debug : phy(29), attached_handle(0x0005): target responding: link rate: new(0x0b), old(0x00)

 

[mariol]

does not show me the disk in the UI

You mean "Nodename -> Disks"?


Which version of Proxmox are you using?

pveversion -v

Please give me also the output of

dmesg | grep mpi3mr

and

lsblk --ascii -M -o +HOTPLUG,ROTA,PHY-SEC,FSTYPE,MODEL,TRAN,WWN