Hello, I am having a bit of trouble working out what to do with a newly installed PCIe SATA controller in my Proxmox VE. I have installed this card and it connects to 2x HDD hot swap bays on the front of my box. I have confirmed it is working, proxmox sees a drive I have in the bay and lists it in the GUI as an available disk.
My intention is to pass this card to a VM so that I can plug in any HDD's and read/write in that VM, I have followed the steps to enable IOMMU, and confirmed it is enabled but I cannot see my card listed. I do see my GPU but that is a project for another day/VM. There are two SATA controllers on there, one intel which will be the mainboard and one is ASmedia which will be the mainboard chipset (its an Asus x299).
I know there is a way to find out the device ID through the disk, but I am unsure of this command. I am not 100% sure of the make/model of the card it was a cheapish new card off ebay, maybe too cheap...
Thanks for any help received.
My intention is to pass this card to a VM so that I can plug in any HDD's and read/write in that VM, I have followed the steps to enable IOMMU, and confirmed it is enabled but I cannot see my card listed. I do see my GPU but that is a project for another day/VM. There are two SATA controllers on there, one intel which will be the mainboard and one is ASmedia which will be the mainboard chipset (its an Asus x299).
I know there is a way to find out the device ID through the disk, but I am unsure of this command. I am not 100% sure of the make/model of the card it was a cheapish new card off ebay, maybe too cheap...
Thanks for any help received.