Hi,
So, I have proxmox on a very small device.
And I notice the default config is wasting a lot of it.
In particular 1GB of metadata and 1GB of spare metadata, when 32MB each would be sufficient
Also in this case the swap does not help anything and will probably kill the drive if kept.
And of course the thick root, is wasting space as well
I would recommend at least being a little bit smarter with metadata size (and maybe chunk size as well, hdd should get bigger chunks for throughput maybe ?)
And I would make the swap optional, and I heard "zram" is something I should setup ?
Also maybe partition level data compression ?
So, I have proxmox on a very small device.
Code:
=== START OF INFORMATION SECTION ===
Device Model: LITEON IT LST-16S9G-HP
LU WWN Device Id: 5 002303 1004f1458
Firmware Version: 9402
User Capacity: 16,013,942,784 bytes [16.0 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: Solid State Device
Form Factor: < 1.8 inches
TRIM Command: Available, deterministic, zeroed
Device is: Not in smartctl database 7.5/5706
ATA Version is: ACS-3 (minor revision not indicated)
SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Sat Nov 21 16:07:04 2026 EST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
And I notice the default config is wasting a lot of it.
Code:
root@pxtext:~/thin-root-for-proxmox-0.3.43# pvs
PV VG Fmt Attr PSize PFree
/dev/sda3 pve lvm2 a-- 14.41g 8.00m
root@pxtext:~/thin-root-for-proxmox-0.3.43# vgs
VG #PV #LV #SN Attr VSize VFree
pve 1 3 0 wz--n- 14.41g 8.00m
root@pxtext:~/thin-root-for-proxmox-0.3.43# lvs
LV VG Attr LSize Pool Origin Data% Meta% Move Log Cpy%Sync Convert
data pve twi-a-tz-- <4.70g 0.00 1.57
root pve -wi-ao---- 6.70g
swap pve -wi-ao---- 1.00g
root@pxtext:~/thin-root-for-proxmox-0.3.43# lvs -a -o +chunk_size
LV VG Attr LSize Pool Origin Data% Meta% Move Log Cpy%Sync Convert Chunk
data pve twi-a-tz-- <4.70g 0.00 1.57 64.00k
[data_tdata] pve Twi-ao---- <4.70g 0
[data_tmeta] pve ewi-ao---- 1.00g 0
[lvol0_pmspare] pve ewi------- 1.00g 0
root pve -wi-ao---- 6.70g 0
swap pve -wi-ao---- 1.00g 0
root@pxtext:~/thin-root-for-proxmox-0.3.43#
In particular 1GB of metadata and 1GB of spare metadata, when 32MB each would be sufficient
Also in this case the swap does not help anything and will probably kill the drive if kept.
And of course the thick root, is wasting space as well
I would recommend at least being a little bit smarter with metadata size (and maybe chunk size as well, hdd should get bigger chunks for throughput maybe ?)
And I would make the swap optional, and I heard "zram" is something I should setup ?
Also maybe partition level data compression ?