Greetings. I've got a few OVMF firmware VMs with hardware serial ports being passed through (ttyS) mostly successfully.
The issue I am running into is when the VM reboots it outputs to the serial port and receives responses causing the VM to enter various menus. I think I've found the settings I need to change (console input and console output.) Any time I change these setting and save them, I've tried many combinations of the save and apply and F10, but every time the VM restarts or resets those settings are reset to default. I've tried to recreate the EFI disk to see if that was an issue to no success.
I'm out of ideas, does anyone have other suggestions?
The issue I am running into is when the VM reboots it outputs to the serial port and receives responses causing the VM to enter various menus. I think I've found the settings I need to change (console input and console output.) Any time I change these setting and save them, I've tried many combinations of the save and apply and F10, but every time the VM restarts or resets those settings are reset to default. I've tried to recreate the EFI disk to see if that was an issue to no success.
I'm out of ideas, does anyone have other suggestions?