Hi all, recently i've ordered an auction server from hetzner and wanted to run all my vps-vm needs on this auction server. I've followed so many tutorials, applied so many rules and re-installed proxmox so many times in the past week.
Anyway, my problem is getting networking done. To be honest, i was planning to build an OPNSense vm and use OPNSense to redirect appropiate ports to appropiate vm's since most of the vm's im gonna build will be using different ports for main app purposes. The thing is when proxmox installation gets done and i open networking tab it doesnt look like any of the tuts ive seen. Here im leaving screenshot of this as the first sc.
On many tutorials ive seen enp98***f0 device properties are blank, instead vmbr0-1-2-3 etc are filled with ip address and gateway ip. So their vm's work as intented. Screenshot 2 is from gatewayit tuts youtube video.
Since im not even a newbie on networking i dont understand how this works out. Because if i apply appropiate values to bridge i got error on screenshot 3.
If i apply gateway ip to bridge very similar errors pops out saying;
``Parameter verification failed. (400)
gateway: Default gateway already exists on interface 'enp98s0f0'.``
So i thought delete values from network device and apply as seen to bridge. Wow, then i lose my connection to the server. Re-install.
To make it more understandable im also leaving interfaces file sc and my ip page from hetzner.
As you can see ive already ordered an additional ip from hetzner. With the current setup (or the ones ive tried earlier) no bridge makes installed vm's to connect to the internet. I can build them, run them, but no internet connection.
So i belive there is a dead simple solution to this but i cannot get it right. I would be really greatful if someone helps me out on this and tells me how to configure my networking tab.
Thank you in advance.
Anyway, my problem is getting networking done. To be honest, i was planning to build an OPNSense vm and use OPNSense to redirect appropiate ports to appropiate vm's since most of the vm's im gonna build will be using different ports for main app purposes. The thing is when proxmox installation gets done and i open networking tab it doesnt look like any of the tuts ive seen. Here im leaving screenshot of this as the first sc.
On many tutorials ive seen enp98***f0 device properties are blank, instead vmbr0-1-2-3 etc are filled with ip address and gateway ip. So their vm's work as intented. Screenshot 2 is from gatewayit tuts youtube video.
Since im not even a newbie on networking i dont understand how this works out. Because if i apply appropiate values to bridge i got error on screenshot 3.
If i apply gateway ip to bridge very similar errors pops out saying;
``Parameter verification failed. (400)
gateway: Default gateway already exists on interface 'enp98s0f0'.``
So i thought delete values from network device and apply as seen to bridge. Wow, then i lose my connection to the server. Re-install.
To make it more understandable im also leaving interfaces file sc and my ip page from hetzner.
As you can see ive already ordered an additional ip from hetzner. With the current setup (or the ones ive tried earlier) no bridge makes installed vm's to connect to the internet. I can build them, run them, but no internet connection.
So i belive there is a dead simple solution to this but i cannot get it right. I would be really greatful if someone helps me out on this and tells me how to configure my networking tab.
Thank you in advance.
