Search results

Hi, It's one physical network 10Gbit separated into vlans. Based on the logs and performance data collected during the latest backup cycle, here is a summary of the findings. Latency of nfs storage: baseline latency is 0.2ms, under load it is 10ms and it can spike up to 28ms during backups, but...

Hi Fiona, thank you for your reply. We use different and dedicated networks (VLAN) for PBS and NFS traffic. PBS, NFS server and PVE nodes loads and network throughputs and latency are ok and with the same values as always. The backup job doesn't fail on the same vm/lxc, and it fails not...

Hi everyone, at present we have a production environment with 3 nodes Proxmox VE cluster (9.1.6) with a Lenovo DM5000H as NFS (4.2) vm/lxc storage and a dedicated physical Proxmox PBS (4.1.x). PVE nodes e PBS enterprise repos. All the appliance are connected with redundant 10Gbit port switches...

When will be supported Ubuntu 24.04 in enterprise repos? At present (8.2.2) I see pve-container: 5.0.11 Thank you

An update the post. I had the same problem on a fresh install of the latest releases of PBS and PVE, both enterprise repos. The procedure was: Install Proxmox VE, fresh install from latest .iso Switch repository to PVE enterprise repo Install PBS with community repo Switch repository to PBS...

I mean if I can edit the file (where is it?) in which the parameters are written and then eventually reload it in some ways, instead of using command line to set it at runtime, just to remember that I set it in case of cluster upgrade/migration. But command line is fine too. Ok

Could also be hardcoded in a configuration file? What is the default startall-onboot-delay? Startall-onboot-delay could be set per storage and not globally? Thanks for your support

I agree, but when different systems, like servers and storages, start at the same time, there could be a misalignment of some minutes. The retry actions to mount the storage nfs and start a vm how long will go after PVE node boot?

The shared storage was also badly switched off during the power loss, so it could be possible it would take some time to boot and recover properly. #cat /etc/pve/storage.cfg dir: local path /var/lib/vz content iso,vztmpl,backup lvmthin: local-lvm thinpool data vgname pve...

in attachment, journalctl -b -0

-- Journal begins at Mon 2021-09-20 16:22:32 CEST, ends at Mon 2022-02-28 12:17:01 CET. -- Feb 24 17:15:01 pve2 systemd[1]: Starting The Proxmox VE cluster filesystem... Feb 24 17:15:01 pve2 pmxcfs[2218]: [quorum] crit: quorum_initialize failed: 2 Feb 24 17:15:01 pve2 pmxcfs[2218]: [quorum]...

We have a 3-node production Cluster (enterprise repo) with Dell PowerEdge r740XD with both local and shared storage. After power loss in the datacenter VM on Proxmox cluster didn't start at boot, even if Start at boot is set to yes. pveversion -v proxmox-ve: 7.1-1 (running kernel...

I checked on Dell site: https://www.dell.com/support/kbdoc/en-it/000175879/support-for-openmanage-enterprise?lang=en There is a virtual appliance for KVM too for Dell EMC OpenManage Enterprise. Did anyone deploy it on Proxmox 7? How big should be the qcow2 hard disk to configure the new vm...

Now it seems ok: proxmox-backup: 2.1-1 (running kernel: 5.13.19-3-pve) proxmox-backup-server: 2.1.4-1 (running version: 2.1.4) pve-kernel-helper: 7.1-8 pve-kernel-5.13: 7.1-6 pve-kernel-5.13.19-3-pve: 5.13.19-7 pve-kernel-5.13.19-2-pve: 5.13.19-4 ifupdown2: 3.1.0-1+pmx3 libjs-extjs: 7.0.0-1...

# apt install --reinstall proxmox-backup Reading package lists... Done Building dependency tree... Done Reading state information... Done The following NEW packages will be installed: proxmox-backup 0 upgraded, 1 newly installed, 0 to remove and 5 not upgraded. Need to get 2,820 B of...

I don't have third party repository, the output of the commands are: #apt update Get:1 http://security.debian.org bullseye-security InRelease [44.1 kB] Hit:2 http://ftp.it.debian.org/debian bullseye InRelease Get:3 http://security.debian.org bullseye-security/main amd64...

Hi, we have a DELL R740xd server with both PVE (7.1-10) and PBS (2.1-4) installed with Enterprise repository. It was a fresh install from PVE recent iso, then enabling PVE enterprise repo and PBS non-enterprise repo. Finally today we disabled PBS non-enterprise repo, then enabled the enterprise...

We are going to set up an environment with 2 servers, one for production use with PVE (PVE1) and the second with both PBS and PVE (PVE2, used for restore of PVE1 VMs in case of DR) installed. PVE1 server will backup many VMs to a datastore (datastore1) on the PBS server. The goal is to provide...

Hi everyone, are there any updates about using the same datastore of one PBS backup shared as the same target of backup between 2 PVE datacenters? Thanks a lot Tommaso

We had problems with active-backup bonding with BCM57412 NetXtreme-E 10Gb in Dell R740xd and VLAN. pve-manager/7.0-11/63d82f4e Ethernet Channel Bonding Driver: v5.11.22-4-pve Active-backup bonding did't work with VLAN if the bonding was on different network interface cards. After disconnecting...