Search results

Mostly yes but isn't that untrue for the 1 PG listed in the health warning as unavailable?

Please consider two points of clarification from my OP: a) The total of all data is smaller than the smallest OSD -> shouldn't it therefore still get distributed to all three nodes? b) For troubleshooting this problem i have already had the hdds set to up/out -> Does this not create the...

I have setup a three node ceph cluster with 8 OSDs. My goal is to be able to tolerate one node failure without losing data access. To test this i put a couple of ISOs and vm backups (80 GB total) on the cephfs, waited until it reached steady state and then shut down one node (gracefully). All my...

Hi thanks for the hint and the quick reply - i will try the rescan. Being able to have a working console instead of using the video parameters sounds amazing, unfortunately i am on an nvidia gpu and threadripper cpu (so no iGPU console either) and can't justify upgrading yet so no AMD for a...

is it possible you are using the systemd bootloader and not grub? If you chose zfs as a file system you will need to edit /etc/kernel/cmdline and run proxmox-boot-tool refresh instead.

I came across this post because i also started having problems on a running system with Bar 0 can't reserve after upgrading to 7.2/5.15. I have set video=efifb:off video=vesafb:off video=simplefb:off and now i do get Bar 1 can't reserve and see that the memory is in fact taken by bootfb - what...

I am posting from a TRX40 System with a single GPU which is supposed to be passed through on a headless (and gpu-less) PVE. I have the systemd command line set with video=vesafb:off video=efifb:off but i still have the problem unless i unplug everything from my GPU during boot and only plug it...

+1

Hi, thanks for the feedback and the help It was a comment in another similar problem thread, i dont think its a doc problem. Maybe it would be useful as a hint in the official passthrough guide since most community guides i saw dont mention the systemd way.

I now edited /etc/kernel/cmdline instead (just added intel_iommu=on without quotes to the end), ran proxmox-boot-tool refresh and voila: root@homelab:~# dmesg | grep -e DMAR -e IOMMU [ 0.007031] ACPI: DMAR 0x00000000B93099B0 0000A8 (v01 ALASKA A M I 00000001 INTL 00000001) [ 0.007057]...

Hi, i did a fresh install, modified and updated grub again and your cat shows: initrd=\EFI\proxmox\5.11.22-1-pve\initrd.img-5.11.22-1-pve root=ZFS=rpool/ROOT/pve-1 boot=zfs You are probably on to something: I assume this means it loaded the line below the one i modified? My /etc/default/grub...

Hello everyone, i have been trying different guides (beginners guide on /r/homelab, craftcomputing, proxmox official) with my 9700k on a Z370P-D3 running a fresh proxmox 7.0.8 to pass through my 2080ti. However, proxmox still shows “No IOMMU detected, please activate it. See Documentation for...

Thank you very much, that was it

Hello everyone, i just installed proxmox for the first time and after the installation followed https://pve.proxmox.com/wiki/Developer_Workstations_with_Proxmox_VE_and_X11 since i needed to get some vms going for work and didn‘t have any client on hand. Now whenever i open chromium and navigate...