Very good point. Haven't thought about future proof of the settings.
So here is what I change to :
VMBR0: management (unchanged) with bridge port to eno1
VMBR1: VLAN Aware with bridge port to eno2
VMBR10: VLAN aware with bridge port to eno2.10
VMBR100: VLAN aware with bridge port to eno2.100...
Yeah. I have it on 10G now. Once I upgrade my NAS, I will need to free up one of the 10G ports. The 10G does make uploading ISO a breeze. I think I will physically separate the connections. This is my only dual home device and I use a firewall to separate the traffic between VLANs.
What I end...
Thank you for the suggestion. I will be setting up VLAN and move the management interface to VLAN1 (as with most of my management portals for my networking gear).
Thank you. I guess I will properly do that. Bandwidth should not be an issue as it is a dual 10G ethernet connection. I guess I will move the management port to the 1G port for vlan1 and use a single 10G port for both VLAN. I should not expect to use much bandwidth for management other than...
Just install my Proxmox server. My server has a dual Nic. Each nic port is connected to a VLAN switch port that serves two separate VLANs (port 2 for VLAN 10, port 3 for VLAN 100). The topology is below:
Here is what is on the console
on the GUI
and in the /etc/network/interfaces
I am...
Just install my first Proxmox box. The server has two nic. Each nic plug into a VLAN switch port that serves a separate VLAN. During install, the installer creates a VMBR0 for the management IP. Now I cannot create another VMBR to the 192.168.100.x network. It said the GW already exists. Below...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.