Recent content by Ultraformer

Very good point. Haven't thought about future proof of the settings. So here is what I change to : VMBR0: management (unchanged) with bridge port to eno1 VMBR1: VLAN Aware with bridge port to eno2 VMBR10: VLAN aware with bridge port to eno2.10 VMBR100: VLAN aware with bridge port to eno2.100...

Yeah. I have it on 10G now. Once I upgrade my NAS, I will need to free up one of the 10G ports. The 10G does make uploading ISO a breeze. I think I will physically separate the connections. This is my only dual home device and I use a firewall to separate the traffic between VLANs. What I end...

Thank you for the suggestion. I will be setting up VLAN and move the management interface to VLAN1 (as with most of my management portals for my networking gear).

Thank you. I guess I will properly do that. Bandwidth should not be an issue as it is a dual 10G ethernet connection. I guess I will move the management port to the 1G port for vlan1 and use a single 10G port for both VLAN. I should not expect to use much bandwidth for management other than...

Just install my Proxmox server. My server has a dual Nic. Each nic port is connected to a VLAN switch port that serves two separate VLANs (port 2 for VLAN 10, port 3 for VLAN 100). The topology is below: Here is what is on the console on the GUI and in the /etc/network/interfaces I am...

Just install my first Proxmox box. The server has two nic. Each nic plug into a VLAN switch port that serves a separate VLAN. During install, the installer creates a VMBR0 for the management IP. Now I cannot create another VMBR to the 192.168.100.x network. It said the GW already exists. Below...