Recent content by ualex

I would run memtest and a cpu stress test to check if the N100 does not crash.

I found a workaround, by editing the /etc/default/grub file (run update-grub :) ) and append to GRUB_CMDLINE_LINUX_DEFAULT the following: pcie_port_pm=off pcie_aspm.policy=performance

I have a NUC13 with a i226v 2.5Gbit/sec NIC, running on 1Gbit/sec. Proxmox 8 is installed, with the latest kernel. My internet is 1Gbit/sec down/up. All testing is down directly on the Proxmox itself, no VM. On my other NUC8 the speed is always 1Gbit/sec down/up, whatever I do. When I use scp...

Yes here too. Ventoy works fine with 8.0, but not with 8.1

https://enterprise.proxmox.com/iso/proxmox-ve_8.0-2.iso

No, not related. I tested via via USB passthrough and "usbip". With my Z-Wave I had too many drops/retries with passthrough and with "usbip" zero issues. That is why I moved fully to "usbip" (it is also more flexible).

I cancelled my original order, it continue to shift the date. I ordered on Monday from Mouser (EU) and it got shipped out on Monday and it arrived today :-) I will install it tonight in my second NUC13. BTW - i did a bit more testing, but NUC8 TB3 <-> NUC13 TB4 is not really super reliable, so...

The only frustrating part is to automatic bind on start-up, it can be hacked into a service. I made another bash script which does it from, including status, logging, etc. I uploaded it to my gist: https://gist.github.com/ualex73/e6d6088120840a10e126d62fe4061079

I tried a build with Ceph, but did not get CephFS directly to work (gave up quickly, I know) ... but your steps are super helpful, so I will give it another try soon.

Correct, I am from the Netherlands. Good tip for mousser. If my current supplier cannot deliver it in a week orso, I will cancel and order there. I am using "usbip" to connect the USB devices inside the Proxmox VMs, because USB device via the hardware is slow and not stable. Technically I can...

Yes, I found the 4000 MTU somewhere in the TB source code, hence the test around it. I am almost happy with my setup, but I think will not build the Ceph storage in my end. I normally do not keep 3 nodes up-and-running, so there is no super benefit for me (my Home Assistant node is connected to...

@scyto I tested with MTU size on the thunderbolt, but it is better to configure 4000. MTU 9000 gives: Accepted connection from 10.0.0.2, port 32842 [ 5] local 10.0.0.3 port 5201 connected to 10.0.0.2 port 32852 [ ID] Interval Transfer Bitrate [ 5] 0.00-1.00 sec 1.30 GBytes...

Thanks for all the testing and experimenting! I will wait on your write-up and continue with my setup.

I am also running "ANRPL357.0027.2023.0607.1754 ", I updated all firmware before I began with the rest. What type of issues did you notice with the ethernet board?

Good it works fine for you, so I have most likely a small typo somewhere and good you spotted the naming of the file. My original files were named 00-thunderboltX.link, but when I copied it ... I change it to 10/11, do not know why :) More testing is required on my side.