Hi all
Would it make sense to have 4 ceph nodes with OSDs and a fifth with just 1 monitor? In all I'd have 6 Proxmox servers where 2 are just used for CPU and RAM (no space for OSDs) whereas one of these would be used to also install a monitor on. So I could have the 4/2 pool rule which makes...
Hi Wolfgang
Thanks so much for your answers! In the meantime I was able to solve most problems and I'm glad you have verified some of my steps taken.
1)
I configured the VLANs on the HW switch, made OVS IntPorts with the vlanXYZ as the name and then added the same VLAN Tag to the VM Network...
Hi all
I've got a general question. I'm new to OpenvSwitch. I have 3 proxmox servers in a cluster. I got openswitch installed on all of them. Each server has a bond of 2 network cards which I then connect to vmbr0. Everything works as excpected so far. Here is an example of a proxmox...
@sb-jw I thought these Sandisks were enterprise https://www.sandisk.com/content/dam/sandisk-main/en_us/assets/resources/enterprise/data-sheets/fusion-iomemory-sx350-pcie-application-accelerators-datasheet.pdf
@Vladimir Bulgaru Yes I'm talking about the Sandisk IoMemory. So you use the previous...
Hi
Has anyone tried the Sandisk SX350-1600 PCI-E for CEPH?
If yes, is it any good? (Maybe you can provide some benchmarks if you have any)
Thanks in advance!
silbro
Thanks for the link. Unfortunately, even after reading the wiki entry, I don't understand how much GB I need to update the metadata pool with and if my above listed command is correct. I see a formula:
PoolSize/ChunkSize * 64b = MetadataPoolSize
But is this for newly created LVMs or do I need...
It is Thin-LVM. The standard one that is created when you install proxmox.
Unfortunately I lose write/read speed this way... But luckily these VMs are just used for calculation mainly and barely any writing, so I can live with that.
Hi Wolfgang
Thank you for your answer. I agree with you, but in this case it's a RAID 1. So the system is installed on a RAID1 and the expansion was a RAID1. So basically it is used as a RAID10 in this case.
I'm guessing that this way it isn't really a problem.
What about the listed steps, is...
Hi all
I want to extend the logical volume data that is default when installing proxmox with another disk. I did this:
1) pvcreate /dev/sdb1
2) vgextend pve /dev/sdb1
3) lvextend /dev/pve/data /dev/sdb1
Is this correct or did I miss something?
When I check the size in the GUI it shows that...
Ok, maybe I was just too stubborn to reboot my other nodes.... because now that I did this, they seem to appear and work fine. Is this normal behaviour?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.