Recent content by elkondor

I know how lxc works. but I ask if compared to a time, lxc can work on classic lvm (old classic disk file for vm machine) and take snapshots without interruption, because kvm/qemu can snapshot in some mode and storage type (sorry for my english)

i need to setup new machine with 6.2 i have old 4.4 with machine without lvm-thin storage and vm in qcow2 file and no lxc. now i interesting to use lxc together kvm. if i set no lvm-thin storage, with new version is possible to backup lxc machine in non lvm-thin storage situation or not? because...

yes, but it seemed absurd to use two SSDs under raid 1 controller since hypothetically the writing life is similar .... if the former dies, the latter may also give up shortly

i need ti upgrade some old PVE install (some homelab that run H24), on occasion I would like to upgrade hw. now i have serverraid 5014 controller raid1 for system , raid1 for vm. i backup VM and config system file on a NAS. I think to put proxmox OS on single SSD (good consumer ssd) and to...

sorry, exist specific section??

pveversion -v proxmox-ve: 4.4-93 (running kernel: 4.4.76-1-pve) pve-manager: 4.4-17 (running version: 4.4-17/70a65945) pve-kernel-4.4.35-1-pve: 4.4.35-77 pve-kernel-4.2.6-1-pve: 4.2.6-36 pve-kernel-4.4.8-1-pve: 4.4.8-52 pve-kernel-4.2.8-1-pve: 4.2.8-41 pve-kernel-4.4.10-1-pve: 4.4.10-54...

i need to remotely change the operating system at startup, I have a problem activating grub-reboot I have a test machine with an old pve 4.4 (but I have also tried with the next version) in dualboot with windows 7 I configure everything (https://wiki.debian.org/GrubReboot) on reboot the item is...

i have upgraded an 4.x to last 4.4 release my datastore virtual machine (kvm) is in classic LVM fs. in a test fresh install of 4.4 i show the new layout of lvm+lvm-thin fs. i have non problem with my configuration in kvm machine, but i need to create some lxc vm container and i not understand...

i need to run windows (XP or 7 for now) guest 32bit ,now i use kvm32 CPU type. but where is the best/good cpu for windows guest operating system normaly? in the cpu dropdown there is a lot of choice... tnks!

ok i read the forum, and in my case i need only to change domani suffix (ex. pvename.local.domain) local.domain in other. i understand that is sufficient edit /etc/hosts and hostname and other service that use this domain. the node not use domain suffix in /etc/pve/nodes/pvename exemple...

i have installed a new 4.2 with some KVM machine (standalone pve) how i change hostname? the debian way? (/etc/hosts /etc/hostname and postfix main.conf ?) orthere are other setting to touch? tnks.

Is possible migrate lvm in lvm-thin with data in lvm partition? or i need to move my KVM virtual machine first?