WOL ( Wake On Lan ) and Proxmox 5.3.5 Help ....

[Fabio]

Good evening,
I have a dell t330 server with PROXMOX. In the BIOS I have enabled the WOL function on both network cards.
Upstream I have a firewall in which I enter the VPN. I wanted to use the Wake On Lan Magic packet utility to turn on proxmox when I need it.
it seems that the card is also enabled by proxmox, with the ethotool eno1 command
Settings for eno1:
Supported ports: [TP]
Supported link modes: 10baseT / Half 10baseT / Full
100baseT / Half 100baseT / Full
1000baseT / Half 1000baseT / Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT / Half 10baseT / Full
100baseT / Half 100baseT / Full
1000baseT / Half 1000baseT / Full
Advertised pause frame use: Symmetric
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT / Half 10baseT / Full
100baseT / Half 100baseT / Full
1000baseT / Full
Link partner advertised pause frame use: No
Link partner advertised auto-negotiation: Yes
Speed: 1000Mb / s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: off
Supports Wake-on: g
Wake-on: g
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes

M, i don't know if i have to configure something else to activate this function?

 

[Fabio]

help me ???

 

[aaron]

This usually also needs some settings in the BIOS to work. A search for that server brought the following result: https://www.dell.com/community/PowerEdge-Hardware-General/DELL-T300-Wake-On-Lan-option/td-p/4584522

Check the last answer.