Hello,
This is my network configuration.
If i tcpdump the eth0 inside a kvm client i get too much information from the vmbr0 interface.
Even http,nfs,ssh traffic from other clients in the same host.
Is this normal?
Can i isolate the traffic somehow?
This is my network configuration.
Code:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet static
address x.x.x.x
netmask x.x.x.x
network x.x.x.x
broadcast x.x.x.x
gateway x.x.x.x
auto eth1
iface eth1 inet static
address 0.0.0.0
netmask 0.0.0.0
auto vmbr1
iface vmbr1 inet manual
bridge_ports dummy0
bridge_stp off
bridge_fd 0
post-up /etc/pve/kvm-networking.sh
auto vmbr0
iface vmbr0 inet static
address 0.0.0.0
netmask 0.0.0.0
bridge_ports eth1
bridge_stp off
bridge_fd 0
auto vmbr0:1
iface vmbr0:1 inet static
address 192.168.1.4
netmask 255.255.255.0
broadcast 192.168.1.255
network 192.168.1.0
If i tcpdump the eth0 inside a kvm client i get too much information from the vmbr0 interface.
Even http,nfs,ssh traffic from other clients in the same host.
Is this normal?
Can i isolate the traffic somehow?