Hey,
I am using Open vSwitch on my PVE nodes, and wanted to integrate Veeams new backup solution to PVE.
But in the current version of Veeam, they do not support Open vSwitch - https://helpcenter.veeam.com/docs/vbproxmoxve/userguide/system_requirements.html?ver=1
My nodes only have 1 NIC, so i tried to use the physical NIC for both the Open vSwitch and the standard bridge (not sure it would work, but had to try).
When applying i get this error message:
Is my config incorrect, or is it more likely that i am trying something unsupported here?
I am using Open vSwitch on my PVE nodes, and wanted to integrate Veeams new backup solution to PVE.
But in the current version of Veeam, they do not support Open vSwitch - https://helpcenter.veeam.com/docs/vbproxmoxve/userguide/system_requirements.html?ver=1
My nodes only have 1 NIC, so i tried to use the physical NIC for both the Open vSwitch and the standard bridge (not sure it would work, but had to try).
Code:
auto lo
iface lo inet loopback
auto enp3s0
iface enp3s0 inet manual
ovs_type OVSPort
ovs_bridge vmbr0
auto vlan10
iface vlan10 inet static
address 192.168.10.21/24
gateway 192.168.10.1
ovs_type OVSIntPort
ovs_bridge vmbr0
ovs_options tag=10
auto vmbr0
iface vmbr0 inet manual
ovs_type OVSBridge
ovs_ports enp3s0 vlan10
auto vmbr1
iface vmbr1 inet manual
bridge_ports enp3s0
bridge_stp off
bridge_fd 0
iface wlp4s0 inet manualWhen applying i get this error message:
Code:
ifreload -a
warning: vmbr1: apply bridge ports settings: cmd '/bin/ip -force -batch - [link set dev enp3s0 master vmbr1]' failed: returned 1 (RTNETLINK answers: Operation not supported
Command failed -:1
)Is my config incorrect, or is it more likely that i am trying something unsupported here?
