I am used to setting the bond in PVE then changing VMBR0 to the bond but made a mistake in PBS as its a little different and set the IP the same for EN0 and the bond and now can’t get in. I tried to SSH into
Resetting network settings to default
- Thread starter Andrew Holybee
- Start date
Well if your Server has no internet connection because the network settings are wrong, you need to find a way to access your Server without Internet.
Depending on where that server is set up, there are a couple of different ways to do this. One would be to take a monitor and keyboard and walk to the server, plug yourself in and change the network settings. If that is not possible because the server is hosted in a datacenter you don't have access to, you could ask for them to give you a KVM. That way you can have access to a keyboard and monitor attached to the server via the internet.
Depending on where that server is set up, there are a couple of different ways to do this. One would be to take a monitor and keyboard and walk to the server, plug yourself in and change the network settings. If that is not possible because the server is hosted in a datacenter you don't have access to, you could ask for them to give you a KVM. That way you can have access to a keyboard and monitor attached to the server via the internet.
Thanks so much I must have been more tired then I thought when I posted. This is my lab and I have physical access I put in the reset network command then the apply command and its working now. I just have to figure out how to do the bond correctly this time as its a little different