Hi,
I am trying to setup a 2+1 cluster with a qdevice configuration following https://pve.proxmox.com/pve-docs/chapter-pvecm.html#_corosync_external_vote_support
I have corosync-qnetd installed on a rpi3b+ with raspbian (debian 10)
I have corosync-qdevice installed on both of my nodes pve 6.2-10.
connectivity is good and checked.
When I run the setup command (pvecm qdevice setup <ip_address>) everything goes well but pvecm status only shows the 2 nodes but not the qdevice node.
I can't see anything wrong in the logs.
Any advice on how to solve it?
Note 1 : attached are the command outputs and the generated configuration file
Note 2 : at first it didn't work because I had the nodes enrolled in freeipa and it messing with the ssh fingerprints. So i did some trials and errors
I am trying to setup a 2+1 cluster with a qdevice configuration following https://pve.proxmox.com/pve-docs/chapter-pvecm.html#_corosync_external_vote_support
I have corosync-qnetd installed on a rpi3b+ with raspbian (debian 10)
I have corosync-qdevice installed on both of my nodes pve 6.2-10.
connectivity is good and checked.
When I run the setup command (pvecm qdevice setup <ip_address>) everything goes well but pvecm status only shows the 2 nodes but not the qdevice node.
I can't see anything wrong in the logs.
Any advice on how to solve it?
Note 1 : attached are the command outputs and the generated configuration file
Note 2 : at first it didn't work because I had the nodes enrolled in freeipa and it messing with the ssh fingerprints. So i did some trials and errors