Hi folks,
tonight I tried to install PVE 7.1 on an HP Microserver Gen10 (not +) machine (AMD Opteron X3421 4 x 2,1 GHz). I used an USB stick which I build from proxmox-ve_7.1-2.iso via dd.
Sadly, the behavior of the installer on this machine is a little bit strange. On the other hand it works fine on VMware
But, on the HP Microserver Gen10 I observed the following behavior:
In BIOS I selected UEFI native boot. The stick is recognized, the installer GUI starts and I choose the first option. Then a kind of terminal windows starts in the middle of the installer screen, i.e. with the installer GUI in the back. Then the GUI and the terminal window disappear and a native fullscreen terminal window is shown. After about 10-15 lines (to fast to remember) the screen gets dark / black an the machine hangs. My monitor indicates there is no video signal available anymore.
How do I get the installer running? Or is there another way to get PVE on this machine? I ask because I had PVE 7.1-10 running on this machine so far, but replaced all my hdd (need more space). I.e. the PVE system running before (and it has been running over years now) is on the old smaller disks (and its backups). But, I want to get a fresh clean installation (where I later will ZFS).
But, first I need the installer running and setting up a fresh and clean system. Are there any know issues, may be /w AMD GPUs? Or is there a guided text mode available? Or would you recommend to choose an older installer and update the system after installation?
What would be your experiences and suggestions?
Anys hints/tipps would be greatly appreciated!
Greetinx
moose
tonight I tried to install PVE 7.1 on an HP Microserver Gen10 (not +) machine (AMD Opteron X3421 4 x 2,1 GHz). I used an USB stick which I build from proxmox-ve_7.1-2.iso via dd.
Sadly, the behavior of the installer on this machine is a little bit strange. On the other hand it works fine on VMware
But, on the HP Microserver Gen10 I observed the following behavior:
In BIOS I selected UEFI native boot. The stick is recognized, the installer GUI starts and I choose the first option. Then a kind of terminal windows starts in the middle of the installer screen, i.e. with the installer GUI in the back. Then the GUI and the terminal window disappear and a native fullscreen terminal window is shown. After about 10-15 lines (to fast to remember) the screen gets dark / black an the machine hangs. My monitor indicates there is no video signal available anymore.
How do I get the installer running? Or is there another way to get PVE on this machine? I ask because I had PVE 7.1-10 running on this machine so far, but replaced all my hdd (need more space). I.e. the PVE system running before (and it has been running over years now) is on the old smaller disks (and its backups). But, I want to get a fresh clean installation (where I later will ZFS).
But, first I need the installer running and setting up a fresh and clean system. Are there any know issues, may be /w AMD GPUs? Or is there a guided text mode available? Or would you recommend to choose an older installer and update the system after installation?
What would be your experiences and suggestions?
Anys hints/tipps would be greatly appreciated!
Greetinx
moose