[SOLVED] Proxmox newbie: Error 1006 when launching Shell or Update

[myatix]

Hi All,

I have a completely new install of Proxmox 8.2.2 with a single node and no cluster setup. I recently tried to update the node and I get an error:

TASK ERROR: command '/usr/bin/termproxy 5900 --path /nodes/pve01 --perm Sys.Console -- /usr/bin/pveupgrade --shell' failed: exit code 1

The same error occurs if I try to open the shell or run an update from the GUI interface in Safari.

Here is my /etc/hosts config:

127.0.0.1 localhost.localdomain localhost
192.168.1.124 pve01.local pve01

 

[fireon]

hmm... are you using a proxy/reverse proxy or something else?

With a single node, this message should not appear. Do you see something in the logs? So please execute this command while you reproducing the error via SSH:

journalctl -f

Have all services been started cleanly?

systemctl --failed

 

[myatix]

@fireon Thank you for the response.

No services have failed and the response to the journalctl -f is below.

It doesn't mean a lot to me to be honest but I really appritiate the assistance.

 

[fireon]

Interesting...
Please post the output of the following commandos and please use the code function for a good overview, then it will be easier for us here

journalctl -r -p4

dmesg -l err

mount

lsblk -o +fstype

df -h

 

[myatix]

Hi Again,

I found the solution it would appear that it didn't like my version of safari browser. When I used Chrome the issue went away.

Safari Version 15.6.1

 

[fireon]

Hi Again,

I found the solution it would appear that it didn't like my version of safari browser. When I used Chrome the issue went away.

Safari Version 15.6.1

unbelievable...

Perfect . Please mark your thread as "solved". You can do this by editing your first post and setting the flag.