Proxmox Need to add HPE MSA storage through SAN switch

[santhakumar]

Hi recently we added lun from hoe storage but its not visible im console we tried lot of times

 

[kawano-y]

Are you using Fibre Channel or iSCSI to connect the HPE MSA storage?
Also, can the Proxmox host detect the LUN at the operating system level?

Please provide the output of the following commands:

lsblk
lsscsi -t
multipath -ll

 

[santhakumar]

HI
Thanks for reply

We are using FC not iscsi

Im attached snapshots for your reference

 

[kawano-y]

If possible, please share the command output as text rather than screenshots. Please redact any sensitive information before posting.

 

[alexskysilk]

Troubleshooting order:

1. Did you map your luns to your PVE HBA WWN?
2. does your HBA see the LUN during boot?
3. Whats the make and model of your HBA? are you using the default drivers that shipped with debian, or did you install a outside driver?

 

[bbgeek17]

lsblk
lsscsi -t
multipath -ll

This is the key ! ^

https://kb.blockbridge.com/technote/proxmox-lvm-shared-storage/

---

Blockbridge : Ultra low latency all-NVME shared storage for Proxmox - https://www.blockbridge.com/proxmox

 

[devaux]

https://pve.proxmox.com/wiki/Multipath