Need tagging network help

[tl5k5]

Hey all,
I have a functioning 10Gb Proxmox server.
I have multiple VLANs configured on my switch.
Proxmox/VMs are only communicating with a single VLAN.
If I wanted to have all VLANs connect to the server via the 10Gb port I can tag the port on the switch, but what kind of config do I need on the server side?

Sorry, I'm not much of a networking guy...but I'm all we have.

Thanks!

 

[LnxBil]

If your switch tagging is correct, you just need to enter the VLAN id in the corresponding field at VM or container network configuration

 

[tl5k5]

So there's no configuration I need to place on the Proxmox 10Gb to make the other VLANs accessible? Does anyone have an example config I can look at to get my head wrapped around this? Thanks!

 

[LnxBil]

Have you tried just setting the VLAN ID?

 

[tl5k5]

Not yet. It's hard to find the time with all the other hats I wear.
I must be thinking it's harder to set up than it is. I'll eventually get around to giving it a try. Thanks!

 

[LnxBil]

Not yet. It's hard to find the time with all the other hats I wear.
I must be thinking it's harder to set up than it is. I'll eventually get around to giving it a try. Thanks!

Hmm .. it takes one minute to configure and another to try out. I use it on a daily basis and it works like a charm: