Need example of host's fstab and default grub config

Running here only with ZFS:
Code: 
cat /etc/fstab  
# <file system> <mount point> <type> <options> <dump> <pass> 
/dev/zvol/rpool/swap none swap sw 0 0 
proc /proc proc defaults 0 0
Code: 
cat /etc/default/grub 
# If you change this file, run 'update-grub' afterwards to update 
# /boot/grub/grub.cfg. 
# For full documentation of the options in this file, see: 
#  info -f grub -n 'Simple configuration' 

GRUB_DEFAULT=0 
GRUB_TIMEOUT=5 
GRUB_DISTRIBUTOR="Proxmox Virtual Environment" 
GRUB_CMDLINE_LINUX_DEFAULT="quiet intel_iommu=on rootdelay=5" 
GRUB_CMDLINE_LINUX="root=ZFS=rpool/ROOT/pve-1 boot=zfs" 

# Disable os-prober, it might add menu entries for each guest 
GRUB_DISABLE_OS_PROBER=true 

# Uncomment to enable BadRAM filtering, modify to suit your needs 
# This works with Linux (no patch required) and with any kernel that obtains 
# the memory map information from GRUB (GNU Mach, kernel of FreeBSD ...) 
#GRUB_BADRAM="0x01234567,0xfefefefe,0x89abcdef,0xefefefef" 

# Uncomment to disable graphical terminal (grub-pc only) 
#GRUB_TERMINAL=console 

# The resolution used on graphical terminal 
# note that you can use only modes which your graphic card supports via VBE 
# you can see them in real GRUB with the command `vbeinfo' 
#GRUB_GFXMODE=640x480 

# Uncomment if you don't want GRUB to pass "root=UUID=xxx" parameter to Linux 
#GRUB_DISABLE_LINUX_UUID=true 

# Disable generation of recovery mode menu entries 
GRUB_DISABLE_RECOVERY="true" 

# Uncomment to get a beep at grub start 
#GRUB_INIT_TUNE="480 440 1"
 
  • Like
Reactions: JBB
For future time savings:

Just install the system again in a (Proxmox VE) VM and check for yourself. It's always good to have a Proxmox VE system to play around if you do not have experience.
 
You must log in or register to reply here.
Top Bottom
Back