Need advice
- Thread starter jonnboy
- Start date
I never expected it to be easy but can you point me to the right direction on how I can do it ?
I`m trying to make a completely hide VM .
well i guess *if* it is possible, you would have to compile your own ovmf images with the values you need
you can check out here https://git.proxmox.com/?p=pve-edk2-firmware.git;a=summary how we compile them
sidenote, it is basically impossible to *completely* hide the fact that you are running a vm. there are so many ways to determine that (e.g. timing side-channels) that it's not realistically possible.
though most applications do not look very deep to determine that so you might trick them
though most applications do not look very deep to determine that so you might trick them
Thank you Sir for your help. Sidenote I went and installed Unraid just to check out if it were posible there and it`s actually very easy , I edited just the KMV XML file and that`s it all my Board and Bios info was there like magic
.Now my new question , would be possible to use similar args in the QEMU config file ? too change the bios info I just used the smbios entry followed by mode= sysinfo , soomething like this <smbios mode='sysinfo'/>
ok if its just the smbios info you need, you can edit most options under 'Options -> SMBIOS Settings'
you have to enter it manually though, we do not have an 'auto-populate from host' feature, but you can open a
bugzilla feature request here: https://bugzilla.proxmox.com
such an option might make sense (best to also include the unraid config change)
you have to enter it manually though, we do not have an 'auto-populate from host' feature, but you can open a
bugzilla feature request here: https://bugzilla.proxmox.com
such an option might make sense (best to also include the unraid config change)
Using this method I can pass the "Manufacturer" entry, however there is no way to add also "Vendor" which is required by one of my guest systems. How to add in in Proxmox?
