steps:
1. installed a new 1tb SSD into server
2. configured a new thinpool on the web UI
3. hit Create VM... set the target to my new thinpool
- I see the "Logical olume "vm-106-disk-0" created message
- the create never actually finishes (left it running for 24hrs once, just in case)
or 3. right click on a template... Clone... FullClone, target = my new thinpool
-- disk is created, transfer starts
- transfer stalls out every time at exactly 7.4gb or 20gb
also tested it cloning a different non-template VM, dies at Exactly the same point.
Any suggestions on where to start?
1. installed a new 1tb SSD into server
2. configured a new thinpool on the web UI
3. hit Create VM... set the target to my new thinpool
- I see the "Logical olume "vm-106-disk-0" created message
- the create never actually finishes (left it running for 24hrs once, just in case)
or 3. right click on a template... Clone... FullClone, target = my new thinpool
-- disk is created, transfer starts
- transfer stalls out every time at exactly 7.4gb or 20gb
also tested it cloning a different non-template VM, dies at Exactly the same point.
Any suggestions on where to start?