Hi,
as soon as i add a new virtual network card to the same bridge, the vm (Win2K8) can't see the outside world / even the host. No improvement if this new card is disabled in the vm.
If i remove the virtual card all works correctly.
If i add a new virtual network card to another bridge it works ok.
Is this a known limitation ?
Is there a network option to activate on the host ?
Non working conf:
#brctl show
bridge name bridge id STP enabled interfaces
vmbr0 8000.002590115dc2 no eth0
tap220i0d0
tap220i0d1
tap225i0d0
vmbr10 8000.002590115dc2 no eth0.4000
tap200i10d0
tap205i10d0
tap220i10d0
tap225i10d0
vm 220 .conf:
# cat /etc/qemu-server/220.conf
name: back100
ide2: local:iso/nnn.iso,media=cdrom
bootdisk: virtio0
ostype: w2k8
memory: 2048
sockets: 1
virtio0: nas1:220/vm-220-disk-1.raw
boot: cad
freeze: 0
cpuunits: 1000
acpi: 1
kvm: 1
onboot: 1
cores: 1
vlan10: virtio=CC:CC:CC:CC:CC:08
vlan0: virtio=DD:00:00DDD,virtio=EE:EE:EE:EE:EE:EE
args: -no-hpet -no-kvm-pit-reinjection
as soon as i add a new virtual network card to the same bridge, the vm (Win2K8) can't see the outside world / even the host. No improvement if this new card is disabled in the vm.
If i remove the virtual card all works correctly.
If i add a new virtual network card to another bridge it works ok.
Is this a known limitation ?
Is there a network option to activate on the host ?
Non working conf:
#brctl show
bridge name bridge id STP enabled interfaces
vmbr0 8000.002590115dc2 no eth0
tap220i0d0
tap220i0d1
tap225i0d0
vmbr10 8000.002590115dc2 no eth0.4000
tap200i10d0
tap205i10d0
tap220i10d0
tap225i10d0
vm 220 .conf:
# cat /etc/qemu-server/220.conf
name: back100
ide2: local:iso/nnn.iso,media=cdrom
bootdisk: virtio0
ostype: w2k8
memory: 2048
sockets: 1
virtio0: nas1:220/vm-220-disk-1.raw
boot: cad
freeze: 0
cpuunits: 1000
acpi: 1
kvm: 1
onboot: 1
cores: 1
vlan10: virtio=CC:CC:CC:CC:CC:08
vlan0: virtio=DD:00:00DDD,virtio=EE:EE:EE:EE:EE:EE
args: -no-hpet -no-kvm-pit-reinjection