I have a new build on an XDTH-6f.
I have set the XDTH-6f SAS2008 to be in IT Mode
I have an additional m1015 Crossflashed to 9211-IT Mode
Theoretically I have two of the same controllers
I can see all of the disk when doing the initialization, but I can't do anything to the disk
These are fresh, brand new disks
The error I get from command line when I "fdisk c50000...." is "cannot stat disk"
Is there some BIOS setting I am missing? During installation, it took forever to "seek disk", I had to install with all drives pulled except for one.
Any clues on what to do?
I have set the XDTH-6f SAS2008 to be in IT Mode
I have an additional m1015 Crossflashed to 9211-IT Mode
Theoretically I have two of the same controllers
I can see all of the disk when doing the initialization, but I can't do anything to the disk
These are fresh, brand new disks
The error I get from command line when I "fdisk c50000...." is "cannot stat disk"
Is there some BIOS setting I am missing? During installation, it took forever to "seek disk", I had to install with all drives pulled except for one.
Any clues on what to do?