How to refresh the installation interface?

K

kouki

New Member
Sep 8, 2022
3
0
1
I installed a new driver when installing the system, but the newly loaded hard disk cannot be seen in the installation interface. How can I refresh the installation interface?
 
Last edited:
Maybe a translation problem, but what do you mean by "interstallation interface"?

If you mean the installer and you don't see your disks, please check if you're using a raid controller an configure the disk (hopefully disks) in your RAID controller. After that it should be visible by the installer.
 
To see newly added drives while the installer is already running you would simply need to exit and run the proxinstall script again.

However, giving some more information would be helpful here. What driver are you exactly installing and what is your hard disk layout? How are you intending to run Proxmox on this special driver, as the default Proxmox installation will most likely not include it?
 
datschlatscher said:
To see newly added drives while the installer is already running you would simply need to exit and run the proxinstall script again.

However, giving some more information would be helpful here. What driver are you exactly installing and what is your hard disk layout? How are you intending to run Proxmox on this special driver, as the default Proxmox installation will most likely not include it?
Click to expand...
I want to install High Point NVMe RAID Controller, but after installing the driver, I cannot see the created RAID.
Do I need to restart the installer, or this driver is not supported？
 
You must log in or register to reply here.
Top Bottom