HDD got renamed by itself?

J

Jarvar

Well-Known Member
Aug 27, 2019
317
10
58
Hello. I have some odd behaviour occuring with my node.
I have dual 240GB drives for the OS and then dual 960GB drives for storage of VMS.
Normally the naming was sda and sdb for the OS drives and sdc and sdd for the storage drives.
I run smartctl through cron daily and noticed that sda was missing a few days ago.
I checked the gui and it shows now sdb, sdc,sdd and sde. How would my system rename the drives by themselves? Is there any way to revert it back? or is there some bigger issue going on? Thanks.
 
Hi, to avoid such problems you should use uuids instead
Code: 
ls -lah /dev/disk/by-uuid
 
Dominic said:
Hi, to avoid such problems you should use uuids instead
Code: 
ls -lah /dev/disk/by-uuid
Click to expand...
Thank you. Sorry I have been preoccupied with other matters. Is this normal behaviour?
I have several nodes and have setup several nodes in the past which had crontabs set to report on sda, sdb, sdc and sdd which worked without issue. However with this one server, the hdd got renamed by itself. The whole system is functioning, just that these things got shifted over.
I will probably go through the process of doing this the way you suggested, but wondering why it would even rename them and shift them over?
Anything to be concerned about?
 
Is this normal behaviour?
Click to expand...
Yes, that the names /dev/sda, /dev/sdb can change is normal :)

If your machine has more than one SATA, SCSI or IDE disk controller, the order in which their corresponding device nodes are added is arbitrary. This may result in device names like /dev/sda and /dev/sdb switching around on each boot, culminating in an unbootable system, kernel panic, or a block device disappearing. Persistent naming solves these issues. [0]
Click to expand...

[0] https://wiki.archlinux.org/title/Persistent_block_device_naming
 
You must log in or register to reply here.
Top Bottom