GUI login problem

[eugenyh]

Installed fresh PM2.0 custer
4 Nodes: cl02-n01, cl02-n02, cl02-n03, cl02-n04
On node cl02-n01 created cluster cl02.
On node cl02-n02 maked "pvecm add [ip address cl02-n01]" - successfuly added.
The same for all other nodes 03 and 04.

All login/pass the same at all nodes.

So, starting GUI (from node cl02-n01), entering login/pass, see all 4 nodes.

But, when I click at cl02-n02, GUI asking me login/password again, I entered, GUI ask again... etc.
Hmm...
The same history at cl02-n04,

But!
Cliking at node 3 (cl02-n03) - hehe, all fine: no asking login/pass.

What I do wrong, or what I need to check?

 

[dietmar]

But, when I click at cl02-n02, GUI asking me login/password again, I entered, GUI ask again... etc.

Does it help when you reboot that node? If not, execute the following on that node

# pvecm updatecerts

then reboot. An please make sure that all nodes have correct time.

 

[eugenyh]

Yes!
That's exactly what I missed!


Now I set clocks on all nodes synchronized, and now all working well! Even dont need reboot.


Perhaps better to write this tip here:
http://pve.proxmox.com/wiki/Proxmox_VE_2.0_Cluster#Adding_nodes_to_the_Cluster

 

[tom]

Yes!
That's exactly what I missed!


Now I set clocks on all nodes synchronized, and now all working well! Even dont need reboot.


Perhaps better to write this tip here:
http://pve.proxmox.com/wiki/Proxmox_VE_2.0_Cluster#Adding_nodes_to_the_Cluster

its a wiki, so feel free to add your comments.