Error "Parameter verification failed. (400)" scheduling backup

[egrueda]

Hi all.
I'm creating a backup job and when I click on "Create" button I get this error:

Parameter verification failed. (400)
[B]delete[/B]: property is not defined in schema and the schema does not allow additional properties

Even if I select no VMs, error is generated.
I've configured Compression=none and Mode=snapshot

What is the cause of the error? am I doing it wrong?
Thanks.

P.S. Manual backups are working right, so it might be a GUI issue

 

[egrueda]

New info: error only happens when selection Compression=none.
It won't show that error if selected compression is LZO or GZIP

 

[tom]

try to set it in the first run to LZO or GZIP. save the job. open it again and set it to none. does this workaround works on your side?

 

[egrueda]

Thanks, Tom.
I was just doing that test as seen in bugzilla's #141
Answer is Yes, I can change compression to "none" *after* backup job is created.
I'll leave it that way until bug is fixed

 

[Huub Reemers]

Hi all.
I'm creating a backup job and when I click on "Create" button I get this error:

Parameter verification failed. (400)
[B]delete[/B]: property is not defined in schema and the schema does not allow additional properties

Even if I select no VMs, error is generated.
I've configured Compression=none and Mode=snapshot

What is the cause of the error? am I doing it wrong?
Thanks.

P.S. Manual backups are working right, so it might be a GUI issue

 

[Huub Reemers]

I recieve the next error when I try to configure a backup in a brand new Proxmox installation:
"Parameter verification failed. (400)
vmid: property is missing"

I am new in Proxmox, can't find the solution.
The remark from Tom is not helping me.

 

[dietmar]

You need to select something to backup. Either select some VMs, or change 'Selection mode' setting ...

 

[Huub Reemers]

Yes thanks Dietmar
It was the case. After adding a VM the backup was ok.