I have the current setup, which after two days of trying should be correct. I can't get the iptables nat config to redirect traffic from either my vlan or the interface vmbr1 at all. At this point I can't see any other option...
Test LXC with following config:
produces the following results:
I have no idea on how to proceed from here...
Code:
auto lo
iface lo inet loopback
iface enp2s0f0 inet manual
iface enp2s0f1 inet manual
iface ens2f0 inet manual
iface ens2f1 inet manual
auto vmbr0
iface vmbr0 inet static
address 109.230.xxx.xxx/29
gateway 109.230.xxx.xxx
bridge-ports enp2s0f0
bridge-stp off
bridge-fd 0
# bridge-ports ens2f0
auto vmbr1
iface vmbr1 inet static
address 10.1.0.1/16
bridge-ports ens2f1
bridge-stp off
bridge-fd 0
bridge-vlan-aware yes
bridge-vids 2-4094
post-up echo 1 > /proc/sys/net/ipv4/ip_forward
post-up iptables -t nat -A POSTROUTING -s '10.0.0.0/16' -o vmbr0 -j MASQUERADE
post-down iptables -t nat -D POSTROUTING -s '10.0.0.0/16 ' -o vmbr0 -j MASQUERADE
#10 gig cluster network
auto vmbr1.10
iface vmbr1.10 inet static
address 10.0.0.1/16
Test LXC with following config:
produces the following results:
Code:
v:~# ping 10.0.0.1
PING 10.0.0.1 (10.0.0.1): 56 data bytes
64 bytes from 10.0.0.1: seq=0 ttl=64 time=0.126 ms
64 bytes from 10.0.0.1: seq=1 ttl=64 time=0.098 ms
^C
--- 10.0.0.1 ping statistics ---
2 packets transmitted, 2 packets received, 0% packet loss
round-trip min/avg/max = 0.098/0.112/0.126 ms
v:~# ping 1.1.1.1
PING 1.1.1.1 (1.1.1.1): 56 data bytes
Last edited: