cant access proxmox web gui to install on a dell r610 server

[hoddi16]

Like the title, i cannot access the web gui with the given (https ip 8006) to gain the password to login in the command prompt. i am booting from a bootable usb with balena. i tried it on all 3 different web browser in the same network but failed. During the installation process, i am required to type in ip,subnet,gateway and dns.
How and where do i know the correct ip,subnet,gateway and dns to type in the server? Maybe i typed in the wrong info?
Am i approaching this wrongly? should i config my dell server first? if yes, what must i do in the dell server besides firmware.
please, i have been trying to install for past couple of days and its slowly eating me.

 

[Moayad]

Hi,

Can you ping 8.8.8.8 from you Proxmox VE Server?

How and where do i know the correct ip,subnet,gateway and dns to type in the server?

these are in your network by default proxmox will get ip address by DHCP but you can give a static ip.

Please post output of the following commands:

ip a

cat /etc/network/interfaces

 

[hoddi16]

Pic 1

 

[hoddi16]

 

[hoddi16]

And ping 8.8.8.8 leads to destination not reachable

 

[Moayad]

Thanks,

Pic 1

Can you post full config, i don't seen rest eno2

 

[hoddi16]

Full config

 

[oguz]

can you ping your gateway at 10.0.0.1 ?

are you using a router/switch/firewall? maybe you need to allow the MAC address of the server or something

 

[hoddi16]

no, i cant ping at 10.0.0.1. ethernet cable is connected from the modem to the idrac6 port. i have enabled the mac address of r610 in the modem interface. argg, what can i do?

 

[oguz]

How and where do i know the correct ip,subnet,gateway and dns to type in the server? Maybe i typed in the wrong info?

it depends on your network setup. if you don't know this information ask your system administrator for help...

no, i cant ping at 10.0.0.1.

is that the correct IP for the gateway?

if you cannot reach your gateway then your routing will not work. what is the output of ip r ?