I've searched through the forums and the OpenVZ forums and I can't find a solution.
I've been given a second ip range by my provider. I would like to use this range for new VZ Containers and should be accessible from the public internet. eth0 must be used.
My current /etc/network/interfaces
My new subnet is xxx.xxx.xxx.112/29 - How do I add this to my system? Usable addresses start at 114. Do I have to add 114 to eth0?
Thank you in advance.
I've been given a second ip range by my provider. I would like to use this range for new VZ Containers and should be accessible from the public internet. eth0 must be used.
My current /etc/network/interfaces
Code:
# network interface settings
auto lo
iface lo inet loopback
iface eth0 inet manual
iface eth1 inet manual
auto vmbr0
iface vmbr0 inet static
address xxx.xxx.xxx.98
netmask xxx.xxx.xxx.248
gateway xxx.xxx.xxx.97
bridge_ports eth0
bridge_stp off
bridge_fd 0
My new subnet is xxx.xxx.xxx.112/29 - How do I add this to my system? Usable addresses start at 114. Do I have to add 114 to eth0?
Thank you in advance.
Last edited: