Search results

A virtual machine in a pve6.3 cluster with wireshark software is grabbing packets of traffic mirrored by the switch, and now the traffic mirrored by the switch can only go to the pve host, not to the virtual machine with wireshark. The virtual is not configured with NIC passthrough, it is vmbr1...

Run SLES 11 SP3 on Proxmox 6.3, now disk mode is IDE, want to change to Virtio SCSI My information is as follows: cat /etc/issue Welcome to SUSE Linux Enterprise Server 11 SP3 (x86_64) - Kernel \r (\l). lsmod | grep virtio virtio_net 23032 0 virtio_balloon 13267 0...

I'm LSI 2308, too - IR, I've painted 2038 - It mode, install RAID10, raidz1, and your problem is the same. How to optimize LSI 2308 to find 24 hard disks. thank you very much!

thank you ,I'm doing the part about ProxMox on APT Mirror, it looks a little big, about 140G

This is a Huawei RH2285 server, version 5.4 installed by ISO, and the server cannot be connected to the Internet. Is there an offline way to upgrade to 6.3? I have a computer connected to the Internet. You can install a virtual machine. Install pve5.4 in the virtual machine and use the PVE in...

Thank you for your reply. If only you could reply me earlier. Yesterday, I installed two servers in the way of legacy and started the virtual machine. I have several servers to install now, and I will switch to UEFI mode. If necessary, I migrate the virtual machines on the first two servers and...

I have now upgraded to version 6.3 and formed a cluster with another machine, ready to install more machines. I just configured ZFS to occupy the maximum memory, set it to 1G, and update it. After restarting, I found that the system cannot be started. The error message is as follows Because my...

Thank you, since I have tested it before, I don’t have to worry about installing 6.x I am also installing 5.4 and then upgrading to 6.0. Using zfs raid1 can be installed successfully and enter the system, using zfs raid10 raidz-1 can be installed successfully, can not enter the system, it is...

huawei rh2285h v2 cpu e5-2407 mem 32G disk sas 600G *4 raid car lsi 2308-IT Is there an installation log? Can you locate the cause of the installation failure from the log?

huawei rh2285h v2 cpu e5-2407 mem 32G disk sas 600G *4 raid car lsi 2308-IT Install ProxMox5.4 in ISO mode, select ZFS (RAID1 RAID10 RAIDZ-1) during the installation process, can be successfully installed, but only ZFS RAID1 can boot into the system, the other two modes...